Fanuc Alarm 5040: CAN NOT COMMANDED B–AXS MOVE

Fanuc Alarm 100: PARAMETER WRITE ENABLE Fanuc Control Model: Series 16 / 18 / 21 and 16i / 18i / 21i, 30i / 31i / 32i, 15 / 15i Fanuc Alarm Description On the PARAMETER(SETTING) screen, PWE(parameter writing enabled) is set to 1. Set it to 0, then reset the system. Have you faced Fanuc…

Fanuc Alarm 4522: EXCESS NIBBLING MOVEMENT (C) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In the circular nibbling (G68) or usual nibbling mode, the C-axis traveling distance was larger than or equal to the limit (No. 16194). Have you faced Fanuc Alarm 4522 EXCESS NIBBLING MOVEMENT (C) on…

Fanuc Alarm 4504: ILLEGAL COMMAND IN ARC Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In an arc (G77) command, the radius (I) or the number of holes (K) was set to zero or a negative value. Alternatively, I, J, K, or P was not specified. Have you…

Fanuc Alarm 5220: REFERENCE POINT ADJUSTMENT MODE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A parameter for automatically set a reference position is set. (Bit 2 of parameter No. 1819 = 1) Perform automatic setting. (Position the machine at the reference position manually, then perform manual reference…

Fanuc Alarm 5053: M–NET CONNECT ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Connection time monitoring error (parameter No. 175) Have you faced Fanuc Alarm 5053 M–NET CONNECT ERROR on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and…

Fanuc Alarm 5452: IMPROPER G–CODE (5AXIS MODE) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A G code that cannot be specified is found. (5–axis mode) This alarm is issued when;1) Three–dimensional cutter compensation (side–face offset and leading– edge offset) is applied during cutter compensation, or cutter compensation…