Fanuc Alarm 5013: HPCC: CRC OFS REMAIN AT CANCEL

Fanuc Alarm PS891: ILLEGAL COMMAND G05 Fanus Control Model: Series 15 control (including Series 15-MA, 15-TA, 15-MF, and 15-TF). Description When the G05 command is written incorrectly in the program or the controller detects a technical error in the use of the G05 command. One reason for this alarm is that the G05 command is…

Fanuc Alarm 5122: ILLEGAL COMMAND IN SPIRAL Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A spiral interpolation or conical interpolation command has an error. Specifically, this error is caused by one of the following;1) L = 0 is specified.;2) Q = 0 is specified.;3) R/, R/, C…

Fanuc Alarm 230: R CODE NOT FOUND Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The infeed quantity R has not been instructed for the G161 block. Or the R command value is negative. Correct the program. Have you faced Fanuc Alarm 230 R CODE NOT FOUND on your…

Fanuc Alarm 58: END POINT NOT FOUND Fanus Control Model: 16/18/21 Fanuc Alarm Description In an arbitrary angle chamfering or corner R cutting block, a specified axis is not in the selected plane. Correct the program.

Fanuc Alarm 219: COMMAND G250/G251 INDEPENDENTLY Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description T series G251 and G250 are not independent blocks. Have you faced Fanuc Alarm 219 COMMAND G250/G251 INDEPENDENTLY on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC…