Fanuc Alarm 5006: TOO MANY WORD IN ONE BLOCK
Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series
The number of words specified in a block exceeded 26 in the HPCC mode.
Have you faced Fanuc Alarm 5006 TOO MANY WORD IN ONE BLOCK on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear this error faster!
Fanuc Alarm 5412: NURBS:NO KNOT COMMAND Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description No knot is specified. Alternatively, in NURBS interpolation mode, a block not relating to NURBS interpolation is specified. Have you faced Fanuc Alarm 5412 NURBS:NO KNOT COMMAND on your machine? Share your experience or troubleshooting…
Fanuc Alarm 240: BP/S ALARM Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Background editing was performed during MDI operation Have you faced Fanuc Alarm 240 BP/S ALARM on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear…
Fanuc Alarm 10: Improper G-Code Fanus Control Model: Specific Fanuc model (e.g., Series 0i, 16i, 18i, 21i). Description The machine has received a G-code that it does not recognize or that does not exist in its system. You may have accidentally written an incorrect code, for example, writing G001 or G100 instead of G01, which…
Fanuc Alarm 213: ILLEGAL COMMAND IN SYNCHRO–MODE Fanuc Control Model: Series 0i / 0i-Mate,16 / 18 / 21-Series, 160i/180i/210i and 30i/31i/32i Fanuc Alarm Description Movement is commanded for the axis to be synchronously controlled. Any of the following alarms occurred in the operation with the simple synchronization control.;1) The program issued the move command to…
Fanuc Alarm 5013: HPCC: CRC OFS REMAIN AT CANCEL Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description G05P0 has been specified in G41/G42 mode or with offset remaining Have you faced Fanuc Alarm 5013 HPCC: CRC OFS REMAIN AT CANCEL on your machine? Share your experience or troubleshooting tips…
Fanuc Alarm 5435: PARAMETER OUT OF RANGE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Incorrect parameter setting (set value range) Have you faced Fanuc Alarm 5435 PARAMETER OUT OF RANGE on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators…