Fanuc Alarm 4705: PROGRAM ERROR (OT –)

Fanuc Alarm 4534: W MACRO NUMBER NOT FOUND Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Macro number W specified in a U or V macro command is not stored. Have you faced Fanuc Alarm 4534 W MACRO NUMBER NOT FOUND on your machine? Share your experience or troubleshooting…

Fanuc Alarm 5242: ILLEGAL AXIS NUMBER Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The axis number of the synchronous master axis or slave axis is incorrect. (This alarm is issued when flexible synchronization is turned on.) Alternatively, the axis number of the slave axis is smaller than…

Fanuc Alarm 5138: FSSB: AXIS SETTING NOT COMPLETE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In automatic setting mode, axis setting has not been made yet. Perform axis setting on the FSSB setting screen. Have you faced Fanuc Alarm 5138 FSSB: AXIS SETTING NOT COMPLETE on your machine?…

Fanuc Alarm PS145: G10.1 TIME OUT Fanus Control Model: Fanuc Series 15 (specifically Model B) and sometimes the Series 10, 11, and 12 control systems. Description When the controller fails to receive a response within the time limit for a specific operation. If the G10.1 command is entered with an incorrect format or illogical values,…

Fanuc Alarm 94: P TYPE NOT ALLOWED (COORD CHG) Fanuc Control Model: Fanuc 16 / 18 / 21, 16i/18i/21i, and 30i/31i/32i series Fanuc Alarm Description P type cannot be specified when the program is restarted. (After the automatic operation was interrupted, the coordinate system setting operation was performed.) Perform the correct operation according to the…

Fanuc Alarm 59: PROGRAM NUMBER NOT FOUND Fanus Control Model: 16/18/21 Fanuc Alarm Description In an external program number search, a specified program number was not found. Otherwise, a program specified for searching is being edited in background processing. Alternatively, the program with the program number specified in a one–touch macro call is not found…