Fanuc Alarm 233: DEVICE BUSY
Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series
When an attempt was made to use a unit such as that connected via the RS–232–C interface, other users were using it.
Have you faced Fanuc Alarm 233 DEVICE BUSY on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear this error faster!
Fanuc Alarm 5411: NURBS:ILLEGAL ORDER Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The number of steps is specified incorrectly. Have you faced Fanuc Alarm 5411 NURBS:ILLEGAL ORDER on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear…
Fanuc Alarm 5123: OVER TOLERANCE OF END POINT Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The difference between a specified end point and the calculated end point exceeds the allowable range (parameter 3471). Have you faced Fanuc Alarm 5123 OVER TOLERANCE OF END POINT on your machine? Share…
Fanuc Alarm 5430: ILLEGAL COMMAND IN 3–D CIR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In a modal state in which three–dimensional circular interpolation cannot be specified, a three–dimensional circular interpolation (G02.4/G03.4) is specified. Alternatively, in three–dimensional circular interpolation mode, a code that cannot be specified is…
Fanuc Alarm 400: SERVO ALARM: n–TH AXIS OVERLOAD Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The n–th axis (axis 1–4) overload signal is on. Refer to diagnosis display No. 200, 201 for details. Have you faced Fanuc Alarm 400 SERVO ALARM: n–TH AXIS OVERLOAD on your machine? Share…
Fanuc Alarm 5055: M–NET PRT/FRT ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Vertical parity or framing error Have you faced Fanuc Alarm 5055 M–NET PRT/FRT ERROR on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear…
Fanuc Alarm 5018: POLYGON SPINDLE SPEED ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Function category: Polygon turning;Alarm details: In G51.2 mode, the speed of the spindle or polygon synchronous axis either exceeds the clamp value or is too small. The specified rotation speed ratio thus cannot…