Fanuc Alarm 9: ILLEGAL ADDRESS INPUT
Fanuc Alarm 9: ILLEGAL ADDRESS INPUT
Fanus Control Model: 16/18/21
Fanuc Alarm Description
Unusable character was input in significant area. Modify the program.
Similar Posts
Fanuc Alarm 5032: NEW PRG REGISTERED IN B–AXS MOVE
Fanuc Alarm 5032: NEW PRG REGISTERED IN B–AXS MOVE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description T series While the machine was moving about the B–axis, at attempt was made to register another move command. Have you faced Fanuc Alarm 5032 NEW PRG REGISTERED IN B–AXS MOVE on…
Fanuc Alarm 5123: OVER TOLERANCE OF END POINT
Fanuc Alarm 5123: OVER TOLERANCE OF END POINT Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The difference between a specified end point and the calculated end point exceeds the allowable range (parameter 3471). Have you faced Fanuc Alarm 5123 OVER TOLERANCE OF END POINT on your machine? Share…
Fanuc Alarm 5039: START UNREGISTERED B–AXS PROG
Fanuc Alarm 5039: START UNREGISTERED B–AXS PROG Fanuc Control Model: 0i / 0i-Mate – Model B, 16 / 18 / 21 Fanuc Alarm Description T series An attempt was made to execute a program for the B–axis which had not been registered. Have you faced Fanuc Alarm 5039 START UNREGISTERED B–AXS PROG on your machine? Share…
Fanuc Alarm 4509: ILLEGAL COMMAND IN CUT AT ANGLE
Fanuc Alarm 4509: ILLEGAL COMMAND IN CUT AT ANGLE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In a cut-at-angle (G89) command, the traveling pitch (Q) was set to zero, negative value, or another value larger than or equal to the length (I). Alternatively, I, J, P, or…
Fanuc Alarm 5003: ILLEGAL PARAMETER
Fanuc Alarm 5003: ILLEGAL PARAMETER Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description There is an invalid parameter. Have you faced Fanuc Alarm 5003 ILLEGAL PARAMETER on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear this error…
Fanuc Alarm 231: ILLEGAL FORMAT IN G10 OR L50
Fanuc Alarm 231: ILLEGAL FORMAT IN G10 OR L50 Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Any of the following errors occurred in the specified format at the programmable– parameter input.;1 Address N or R was not entered.;2 A number not specified for a parameter was entered.;3…