Fanuc Alarm 2: TV PARITY ALARM

Fanuc Alarm 10: IMPROPER G–CODE Fanus Control Model: 16/18/21 Fanuc Alarm Description An unusable G code or G code corresponding to the function not provided is specified. Modify the program.

Fanuc Alarm 110: DATA OVERFLOW Fanus Control Model: 10/11/12 Description This is a fault that usually appears when the controller’s data processing system is overloaded. This alarm indicates that the data you are entering into the machine or the calculation system is performing simultaneously has exceeded its memory or register limits. How to Fix Alarm…

Fanuc Alarm 86: DR SIGNAL OFF Fanus Control Model: Fanuc 16, 18, and 21 Series (including i-series), Fanuc 0/0i Series (0-M, 0-T, 0i-MA, 0i-TB, 0i-MC, etc.) Description This simply means that the controller is not receiving a “Data Set Ready” (DSR) signal from the external device PC or laptop. This problem mostly occurs when you…

Fanuc Alarm 1: TH PARITY ALARM Fanus Control Model: 16/18/21 Fanuc Alarm Description TH alarm (A character with incorrect parity was input). Correct the tape.

Fanuc Alarm 34: NO CIRC ALLOWED IN ST–UP /EXT BLK Fanus Control Model: Series 0i / 16i / 18i / 21i / 31i / 32i Description This alarm (Fanuc Alarm 34) occurs when you are starting (Start-up block) or ending (Cancel block) Cutter Radius Compensation using G41 or G42, and write Circular Interpolation (G02/G03) instead…

Fanuc Alarm 47: ILLEGAL AXIS SELECT Fanus Control Model: Fanuc Series 16, 18, 21, and the 16i/18i/21i Model C Description when the control system receives a command to move an axis that has not been properly defined, or when there is a conflict in the axis selection logic. How to Fix Alarm To resolve it,…