Fanuc Alarm 7: ILLEGAL USE OF DECIMAL POINT

Fanuc Alarm 81: OFFSET NUMBER NOT FOUND IN G37 Fanuc Control Model: Fanuc 0i-D/F, 16i/18i/21i, and 30i/31i/32i series Fanuc Alarm Description M series Tool length automatic measurement (G37) was specified without a H code.(Automatic tool length measurement function) Modify the program. Have you faced Fanuc Alarm 81 OFFSET NUMBER NOT FOUND IN G37 on your…

Fanuc Alarm 97: P TYPE NOT ALLOWED (AUTO EXEC) Fanuc Control Model: Fanuc 0i-D/F, 16i/18i/21i, and 30i/31i/32i series Fanuc Alarm Description P type cannot be directed when the program is restarted.(After power ON, after emergency stop or P/S alarm 94 to 97 were reset, no automatic operation is performed).Perform automatic operation. Have you faced Fanuc…

Fanuc Alarm 80: G37 ARRIVAL SIGNAL NOT ASSERTED Fanuc Control Model: Fanuc 0i-D/F, 16i/18i/21i, and 30i/31i/32i series Fanuc Alarm Description M series In the automatic tool length measurement function (G37), the measurement position reach signal (XAE, YAE,or ZAE) is not turned on within an area specified in parameter 6254 (value ε).This is due to a…

Facing is a basic machining operation performed on a CNC lathe, the purpose of which is to cut the end face of a workpiece to a perfectly smooth, straight, and accurate length. The main purpose of facing in a CNC machine is to make the end of the workpiece perfectly smooth, clean and straight so…

Fanuc Alarm 125: FORMAT ERROR IN MACRO Fanuc Control Model: Fanuc 0i-D/F, 16i/18i/21i, and 30i/31i/32i series Fanuc Alarm Description (Formula) format is erroneous. Modify the program. Have you faced Fanuc Alarm 125 FORMAT ERROR IN MACRO on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and…