Fanuc Alarm 64: SHAPE PROGRAM NOT MONOTONOUSLY

Fanuc Alarm 58: END POINT NOT FOUND Fanus Control Model: 16/18/21 Fanuc Alarm Description In an arbitrary angle chamfering or corner R cutting block, a specified axis is not in the selected plane. Correct the program.

Fanuc Alarm 71: DATA NOT FOUND Fanus Control Model: 16/18/21 Fanuc Alarm Description The address to be searched was not found. Or the program with specified program number was not found in program number search. Check the data.

Fanuc Alarm 47: ILLEGAL AXIS SELECT Fanus Control Model: Fanuc Series 16, 18, 21, and the 16i/18i/21i Model C Description when the control system receives a command to move an axis that has not been properly defined, or when there is a conflict in the axis selection logic. How to Fix Alarm To resolve it,…

Fanuc Alarm 62: ILLEGAL COMMAND IN G71–G76 Fanus Control Model: 16/18/21 Fanuc Alarm Description T Series;1. The depth of cut in G71 or G72 is zero or negative value. 2. The repetitive count in G73 is zero or negative value. 3. the negative value is specified to Δi or Δk is zero in G74 or…

Fanuc Alarm 11: NO FEEDRATE COMMANDED Fanus Control Model: 16/18/21 Fanuc Alarm Description Feedrate was not commanded to a cutting feed or the feedrate was inadequate. Modify the program.

Fanuc Alarm PS067: G70–G73 IN FORBIDDEN MODE Fanus Control Model: Most commonly associated with Fanuc Series 0 (0-T/0-TF) and the Series 16/18/21 Description The control system receives a command in G70, G71, G72, or G73 that is incompatible with its specific mode. This problem usually occurs when you run these Canned Cycles in a sub-program…