Fanuc Alarm 5417: NURBS:ILLEGAL MULTI–KNOT
Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series
As many knots as the number of steps are not specified at the start and end points.
Have you faced Fanuc Alarm 5417 NURBS:ILLEGAL MULTI–KNOT on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear this error faster!
Fanuc Alarm 413: SERVO ALARM: n–th AXIS – LSI OVERFLOW Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The contents of the error register for the n–th axis (axis 1–8) exceeded ±231 power. This error usually occurs as the result of an improperly set parameters. Have you faced…
Fanuc Alarm 59: PROGRAM NUMBER NOT FOUND Fanus Control Model: 16/18/21 Fanuc Alarm Description In an external program number search, a specified program number was not found. Otherwise, a program specified for searching is being edited in background processing. Alternatively, the program with the program number specified in a one–touch macro call is not found…
Fanuc Alarm 65: ILLEGAL COMMAND IN G71–G73 Fanus Control Model: 16/18/21 Fanuc Alarm Description T Series;1. G00 or G01 is not commanded at the block with the sequence number which is specified by address P in G71, G72, or G73 command. 2. Address Z(W) or X(U) was commanded in the block with a sequence number…
Fanuc Alarm 5452: IMPROPER G–CODE (5AXIS MODE) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A G code that cannot be specified is found. (5–axis mode) This alarm is issued when;1) Three–dimensional cutter compensation (side–face offset and leading– edge offset) is applied during cutter compensation, or cutter compensation…
Fanuc Alarm 252: ATC SPINDLE ALARM Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description An excessive error arose during spindle positioning for ATC. For details, refer to diagnosis No. 531. (Only for ROBODRILL) Have you faced Fanuc Alarm 252 ATC SPINDLE ALARM on your machine? Share your experience or…
Fanuc Alarm 229: CAN NOT KEEP SYNCHRO–STATE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description T series;This alarm is generated in the following circumstances.;1 When the synchro/mixed state could not be kept due to system overload.;2 The above condition occurred in CMC devices (hardware) and synchro– state could…