Fanuc Alarm 5307: INTERNAL DATA OVER FLOW

Fanuc Alarm 5452: IMPROPER G–CODE (5AXIS MODE) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A G code that cannot be specified is found. (5–axis mode) This alarm is issued when;1) Three–dimensional cutter compensation (side–face offset and leading– edge offset) is applied during cutter compensation, or cutter compensation…

Fanuc Alarm 5403: SPL:CAN NOT MAKE VECTOR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Three–dimensional tool compensation vectors cannot be generated.;· When a three–dimensional tool compensation vector is created for the second or subsequent point, that point, previous point, and next point are on the same straight…

Fanuc Alarm 410: SERVO ALARM: n–TH AXIS – EXCESS ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The position deviation value when the n–th axis (axis 1–8) stops is larger than the set value. Refer to procedure of trouble shooting. Have you faced Fanuc Alarm 410 SERVO…

Fanuc Alarm 5020: PARAMETER OF RESTART ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description An erroneous parameter was specified for restarting a program. A parameter for program restart is invalid. Have you faced Fanuc Alarm 5020 PARAMETER OF RESTART ERROR on your machine? Share your experience or troubleshooting…

Fanuc Alarm 5213: SCREEN COPY: COMMUNICATION ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The memory card cannot be used. Check the memory card. (Check whether the memory card is write–protected or defective.) Have you faced Fanuc Alarm 5213 SCREEN COPY: COMMUNICATION ERROR on your machine? Share your…

Fanuc Alarm 4602: ILLEGAL T-CODE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The specified T command is not cataloged on the tool register screen. Have you faced Fanuc Alarm 4602 ILLEGAL T-CODE on your machine? Share your experience or troubleshooting tips in the comments below to help other…