Fanuc Alarm 5257: G41/G42 NOT ALLOWED IN MDI MODE

Fanuc Alarm 4630: ILLEGAL COMMAND IN LASER MODE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In the laser mode, a nibbling command or pattern command was specified. In the tracing mode, an attempt was made to make a switch to the punching mode. Have you faced Fanuc…

Fanuc Alarm 253: G05 IS NOT AVAILABLE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description M series;Alarm details Binary input operation using high–speed remote buffer (G05) or high– speed cycle machining (G05) has been specified in advance control mode (G08P1). Execute G08P0, to cancel advance control mode, before…

Fanuc Alarm 401: SERVO ALARM: n–TH AXIS VRDY OFF Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The n–th axis (axis 1–8) servo amplifier READY signal (DRDY) went off. Refer to procedure of trouble shooting. Have you faced Fanuc Alarm 401 SERVO ALARM: n–TH AXIS VRDY OFF on your…

Fanuc Alarm 5054: M–NET RECEIVE ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Polling time monitoring error (parameter No. 176) Have you faced Fanuc Alarm 5054 M–NET RECEIVE ERROR on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and…

Fanuc Alarm 28: ILLEGAL PLANE SELECT Fanus Control Model: 16/18/21 Fanuc Alarm Description In the plane selection command, two or more axes in the same direction are commanded. Modify the program.

Fanuc Alarm 5453: NOTE: G68 IS CANCELED Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description When bit 2 of parameter No. 5400 is set to 1, and a reset does not cancel G68, this alarm is issued at the time of program restart. To release this alarm, press…