Fanuc Alarm 5251: ILLEGAL PARAMETER IN G54.2
Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series
A fixture offset parameter (No. 7580 to 7588) is illegal. Correct the parameter.
Have you faced Fanuc Alarm 5251 ILLEGAL PARAMETER IN G54.2 on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear this error faster!
Fanuc Alarm 14: ILLEGAL LEAD COMMAND Fanuc Series 0i (0i-TC, 0i-TD, 0i-TF) Fanuc Series 16i / 18i / 21i Fanuc Series 30i / 31i / 32i Description The wrong feed rate and lead limit of the (Threading) process is higher or lower than the limit set in the program, or there is an error in…
Fanuc Alarm 5448: CRC:INTERFERENCE TO AVD. Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In the interference check evade function of cutter compensation, a further interference occurs for an already created interference evade vector. Have you faced Fanuc Alarm 5448 CRC:INTERFERENCE TO AVD. on your machine? Share your experience…
Fanuc Alarm 407: SERVO ALARM: EXCESS ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The difference in synchronous axis position deviation exceeded the set value. Have you faced Fanuc Alarm 407 SERVO ALARM: EXCESS ERROR on your machine? Share your experience or troubleshooting tips in the comments below…
Fanuc Alarm 4602: ILLEGAL T-CODE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The specified T command is not cataloged on the tool register screen. Have you faced Fanuc Alarm 4602 ILLEGAL T-CODE on your machine? Share your experience or troubleshooting tips in the comments below to help other…
Fanuc Alarm 5157: PARAMETER ZERO Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Zero is set in the parameter for the maximum cutting feedrate (parameter No. 1422 or 1432). Zero is set in the parameter for the acceleration/deceleration before interpolation (parameter No. 1770 or 1771). Set the parameter…
Fanuc Alarm 4503: ILLEGAL COMMAND IN LINE AT ANGLE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In a line-at-angle (G76) command, the number of holes (K) was set to zero or a negative value. Alternatively, I, J, or K was not specified. Have you faced Fanuc Alarm…