Fanuc Alarm 5118: SPL: ERROR
Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series
After manual intervention with manual absolute mode set to on, NURBS interpolation was restarted.
Have you faced Fanuc Alarm 5118 SPL: ERROR on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear this error faster!
Fanuc Alarm 5199: FINE TORQUE SENSING PARAMETER Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A parameter related to the fine torque sensing function is illegal.;· The storage interval is invalid.;· An invalid axis number is set as the target axis. Correct the parameter. Have you faced Fanuc…
Fanuc Alarm 4703: PROGRAM ERROR (OT –) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The value specified in the Y-axis move command exceeded the negative value of stored stroke limit 1. (Advance check) Have you faced Fanuc Alarm 4703 PROGRAM ERROR (OT –) on your machine? Share your…
Fanuc Alarm 65: ILLEGAL COMMAND IN G71–G73 Fanus Control Model: 16/18/21 Fanuc Alarm Description T Series;1. G00 or G01 is not commanded at the block with the sequence number which is specified by address P in G71, G72, or G73 command. 2. Address Z(W) or X(U) was commanded in the block with a sequence number…
Fanuc Alarm 5013: HPCC: CRC OFS REMAIN AT CANCEL Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description G05P0 has been specified in G41/G42 mode or with offset remaining Have you faced Fanuc Alarm 5013 HPCC: CRC OFS REMAIN AT CANCEL on your machine? Share your experience or troubleshooting tips…
Fanuc Alarm 220: ILLEGAL COMMAND IN SYNCHR–MODE Fanuc Control Model: Series 0i-T, 16i/18i/21i-T, and 30i/31i/32i-T Fanuc Alarm Description T series In the synchronous operation, movement is commanded by the NC program or PMC axis control interface for the synchronous axis. Have you faced Fanuc Alarm 220 ILLEGAL COMMAND IN SYNCHR–MODE on your machine? Share your experience…
Fanuc Alarm 101: PLEASE CLEAR MEMORY Fanus Control Model: Series 0, 16, 18, 21 Description When the power is turned off or the controller suddenly shuts down while writing data to memory (such as loading or editing a program), the part of the memory where the data was stored becomes “corrupted.” How to Fix Alarm…