Fanuc Alarm 5116: SPL: ERROR

Fanuc Alarm 4704: PROGRAM ERROR (OT +) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The value specified in the Z-axis move command exceeded the positive value of stored stroke limit 1. (Advance check) Have you faced Fanuc Alarm 4704 PROGRAM ERROR (OT +) on your machine? Share your…

Fanuc Alarm 5039: START UNREGISTERED B–AXS PROG Fanuc Control Model: 0i / 0i-Mate – Model B, 16 / 18 / 21 Fanuc Alarm Description T series An attempt was made to execute a program for the B–axis which had not been registered. Have you faced Fanuc Alarm 5039 START UNREGISTERED B–AXS PROG on your machine? Share…

Fanuc Alarm 5229: WRITE PROTECTED Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A floppy disk in the built–in Handy File is write protected. Have you faced Fanuc Alarm 5229 WRITE PROTECTED on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC…

Fanuc Alarm 5067: (HPCC) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description HPCC mode cannot be canceled during G51 (scaling) or G68 (coordinate system rotation). Correct the program. Have you faced Fanuc Alarm 5067 (HPCC) on your machine? Share your experience or troubleshooting tips in the comments below to…

Fanuc Alarm 5096: MISMATCH WAITING M–CODE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Different wait codes (M codes) were specified in HEAD1 and HEAD2. Correct the program. Have you faced Fanuc Alarm 5096 MISMATCH WAITING M–CODE on your machine? Share your experience or troubleshooting tips in the comments…

Fanuc Alarm 5303: TOUCH PANEL ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A touch panel error occurred. Cause;1. The touch panel is kept pressed.;2. The touch panel was pressed when power was turned on. Remove the above causes, and turn on the power again. Have you…