Fanuc Alarm 5115: SPL: ERROR

Fanuc Alarm 5061: ILLEGAL FORMAT IN G02.3/G03.3 Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The exponential interpolation command (G02.3/G03.3) has a format error. Address I, J, or K is not specified. The value of address I, J, or K is 0. Have you faced Fanuc Alarm 5061…

Fanuc Alarm 5004: HPCC NOT READY Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i Fanuc Alarm Description (M series) High–precision contour control is not ready. Have you faced Fanuc Alarm 5004 HPCC NOT READY on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear…

Fanuc Alarm 5156: ILLEGAL AXIS OPERATION Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In look–ahead control mode (multi blocks are read in advance), the controlled axis selection signal (PMC axis control) changes. In look–achead control mode (multi blocks are read in advance), the simple synchronous axis selection…

Fanuc Alarm 4511: ILLEGAL COMMAND IN CIRCLE-PUNCH Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In a circular punching (G46, G47) command, the same position was specified for both start and end points of the arc, radius (R) of the arc was set to zero, or the pitch…

Fanuc Alarm 60: SEQUENCE NUMBER NOT FOUND Fanus Control Model: 16/18/21 Fanuc Alarm Description Commanded sequence number was not found in the sequence number search. Check the sequence number.

Fanuc Alarm 5124: CAN NOT COMMAND SPIRAL Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A spiral interpolation or conical interpolation was specified in any of the following modes;1) Scaling;2) Programmable mirror image;3) Polar coordinate interpolation In cutter compensation C mode, the center is set as the start…