Fanuc Alarm 5113: CAN NOT ERROR IN MDI MODE
Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series
Look–ahead control (multi blocks are read in advance) (G05.1) was specified in MDI mode.
Have you faced Fanuc Alarm 5113 CAN NOT ERROR IN MDI MODE on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear this error faster!
Fanuc Alarm 224: RETURN TO REFERENCE POINT Fanuc Control Model: 15 /15i, 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description M series Reference position return has not been performed before the automatic operation starts. Perform reference position return only when bit 0 of parameter 1005 is 0. Have you faced Fanuc…
Fanuc Alarm 5401: SPL:ILLEGAL COMMAND Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In a G code mode in which specification of G06.1 is not permitted, G06.1 is specified. Have you faced Fanuc Alarm 5401 SPL:ILLEGAL COMMAND on your machine? Share your experience or troubleshooting tips in the comments…
Fanuc Alarm 5430: ILLEGAL COMMAND IN 3–D CIR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In a modal state in which three–dimensional circular interpolation cannot be specified, a three–dimensional circular interpolation (G02.4/G03.4) is specified. Alternatively, in three–dimensional circular interpolation mode, a code that cannot be specified is…
Fanuc Alarm 80: G37 ARRIVAL SIGNAL NOT ASSERTED Fanuc Control Model: Fanuc 0i-D/F, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description M series In the automatic tool length measurement function (G37), the measurement position reach signal (XAE, YAE,or ZAE) is not turned on within an area specified in parameter 6254 (value ε).This is due to a…
Fanuc Alarm 5300: SET ALL OFFSET DATAS AGAIN Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description After the inch/metric automatic conversion function (OIM: Bit 0 of parameter No. 5006) for tool offset data is enabled or disabled, all the tool offset data must be reset. This message reminds…
Fanuc Alarm 245: T–CODE NOT ALOWEE IN THIS BLOCK Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description T series;One of the G codes, G50, G10, and G04, which cannot be specified in the same block as a T code, was specified with a T code. Have you faced…