Fanuc Alarm 5052: M–NET ETX ERROR
Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series
Abnormal ETX code
Have you faced Fanuc Alarm 5052 M–NET ETX ERROR on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear this error faster!
Fanuc Alarm 5046: ILLEGAL PARAMETER (ST.COMP) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The parameter settings for straightness compensation contain an error. Possible causes are as follows;1. A parameter for a movement axis or compensation axis contains an axis number which is not used.;2. More than 128…
Fanuc Alarm 401: SERVO ALARM: n–TH AXIS VRDY OFF Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The n–th axis (axis 1–8) servo amplifier READY signal (DRDY) went off. Refer to procedure of trouble shooting. Have you faced Fanuc Alarm 401 SERVO ALARM: n–TH AXIS VRDY OFF on your…
Fanuc Alarm 5242: ILLEGAL AXIS NUMBER Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The axis number of the synchronous master axis or slave axis is incorrect. (This alarm is issued when flexible synchronization is turned on.) Alternatively, the axis number of the slave axis is smaller than…
Fanuc Alarm 5243: DATA OUT OF RANGE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The gear ratio is not set correctly. (This alarm is issued when flexible synchronization is turned on.) Have you faced Fanuc Alarm 5243 DATA OUT OF RANGE on your machine? Share your experience or…
Fanuc Alarm 220: ILLEGAL COMMAND IN SYNCHR–MODE Fanuc Control Model: Series 0i-T, 16i/18i/21i-T, and 30i/31i/32i-T Fanuc Alarm Description T series In the synchronous operation, movement is commanded by the NC program or PMC axis control interface for the synchronous axis. Have you faced Fanuc Alarm 220 ILLEGAL COMMAND IN SYNCHR–MODE on your machine? Share your experience…
Fanuc Alarm 5433: MANUAL INTERVENTION IN 3–D CIR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In three–dimensional circular interpolation mode (G02.4/G03.4), manual intervention was made when the manual absolute switch was on. Have you faced Fanuc Alarm 5433 MANUAL INTERVENTION IN 3–D CIR on your machine? Share your…