Fanuc Alarm 5012: G05 P10000 ILLEGAL START UP

Fanuc Alarm 4530: A/B MACRO NUMBER ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The number for storing and calling by an A or B macro was set to a value beyond the range from 1 to 5. Have you faced Fanuc Alarm 4530 A/B MACRO NUMBER…

Fanuc Alarm 5124: CAN NOT COMMAND SPIRAL Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A spiral interpolation or conical interpolation was specified in any of the following modes;1) Scaling;2) Programmable mirror image;3) Polar coordinate interpolation In cutter compensation C mode, the center is set as the start…

Fanuc Alarm 5111: IMPROPER MODAL G–CODE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description M series;An illegal G code is left modal when look–ahead control mode was specified. Have you faced Fanuc Alarm 5111 IMPROPER MODAL G–CODE on your machine? Share your experience or troubleshooting tips in the comments…

Fanuc Alarm 4502: ILLEGAL COMMAND IN BOLT HOLE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In a bolt hole circle (G26) command, the radius (I) was set to zero or a negative value, or the number of holes (K) was set to zero. Alternatively, I, J, or…

Fanuc Alarm 75: PROTECT Fanuc Control Model: Fanuc 0i, 16i / 18i / 21i, 30i / 31i / 32i Fanuc Alarm 75 (PROTECT) is a memory/program protection alarm that occurs when an operator attempts to edit, insert, or delete a program block or parameter while the Program Protect Key is switched ON or memory write…

Fanuc Alarm PS017 ILLEGAL MODE FOR GOTO/WHILE/DO Fanus Control Model: 10/11/12/15/15i Description This alarm appears when the control system has difficulty executing these macro statements such as GOTO, WHILE, or DO. Does your CNC controller accept these specific commands or is there a fundamental error in the program logic that violates the prevailing rules of…