Fanuc Alarm 4650: IMPROPER G-CODE IN OFFSET MODE

Fanuc Alarm 30: ILLEGAL OFFSET NUMBER Fanus Control Model: Series 0/16/18/21/30i/31i/32i Description This alarm occurs when the CNC control is commanded to use a Tool Offset Number that does not exist in the machine’s memory or exceeds the maximum limit defined by your system’s parameters. This problem is usually caused by incorrect use of T-codes…

Fanuc Alarm PS067: G70–G73 IN FORBIDDEN MODE Fanus Control Model: Most commonly associated with Fanuc Series 0 (0-T/0-TF) and the Series 16/18/21 Description The control system receives a command in G70, G71, G72, or G73 that is incompatible with its specific mode. This problem usually occurs when you run these Canned Cycles in a sub-program…

Fanuc Alarm 225: SYNCHRONOUS/MIXED CONTROL ERROR Fanuc Control Model: 16i / 18i / 21 , 0i-T / 0i-TD , 30i / 31i – T series Fanuc Alarm Description T series (At two–path);This alarm is generated in the following circumstances. (Searched for during synchronous and mixed control command.;1 When there is a mistake in axis number…

Fanuc Alarm 5433: MANUAL INTERVENTION IN 3–D CIR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In three–dimensional circular interpolation mode (G02.4/G03.4), manual intervention was made when the manual absolute switch was on. Have you faced Fanuc Alarm 5433 MANUAL INTERVENTION IN 3–D CIR on your machine? Share your…

Fanuc Alarm 212: ILLEGAL PLANE SELECT Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description M series The arbitrary angle chamfering or a corner R is commanded or the plane including an additional axis. Correct the program. Have you faced Fanuc Alarm 212 ILLEGAL PLANE SELECT on your machine? Share…

Fanuc Alarm 5003: ILLEGAL PARAMETER Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description There is an invalid parameter. Have you faced Fanuc Alarm 5003 ILLEGAL PARAMETER on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear this error…