Fanuc Alarm 4533: U/V MACRO MEMORY OVERFLOW
Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series
An attempt was made to store too many macros with a U or V macro command.
Have you faced Fanuc Alarm 4533 U/V MACRO MEMORY OVERFLOW on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear this error faster!
Fanuc Alarm 4521: EXCESS NIBBLING MOVEMENT (X, Y) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In the nibbling mode, the X-axis or Y-axis traveling distance was larger than or equal to the limit (No. 16188 to 16193). Have you faced Fanuc Alarm 4521 EXCESS NIBBLING MOVEMENT (X,…
Fanuc Alarm 5422: EXCESS VELOCITY IN G43.4/ G43.5 Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description As a result of pivot tool length compensation, an attempt was made to move the tool along an axis at a feedrate exceeding the maximum cutting feedrate. Have you faced Fanuc Alarm…
Fanuc Alarm 5013: HPCC: CRC OFS REMAIN AT CANCEL Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description G05P0 has been specified in G41/G42 mode or with offset remaining Have you faced Fanuc Alarm 5013 HPCC: CRC OFS REMAIN AT CANCEL on your machine? Share your experience or troubleshooting tips…
Fanuc Alarm 218: NOT FOUND P/Q COMMAND IN G251 (T series) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm 218 is a Program/Software (P/S) alarm designated specifically for T series (Turning/Lathe) CNC control models. Fanuc Alarm Description T series P or Q is not commanded in the G251 block,…
Fanuc Alarm 5006: TOO MANY WORD IN ONE BLOCK Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The number of words specified in a block exceeded 26 in the HPCC mode. Have you faced Fanuc Alarm 5006 TOO MANY WORD IN ONE BLOCK on your machine? Share your experience…
Fanuc Alarm 4702: PROGRAM ERROR (OT +) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The value specified in the Y-axis move command exceeded the positive value of stored stroke limit 1. (Advance check) Have you faced Fanuc Alarm 4702 PROGRAM ERROR (OT +) on your machine? Share your…