Fanuc Alarm 4506: ILLEGAL COMMAND IN SHARE PROOFS

Fanuc Alarm 220: ILLEGAL COMMAND IN SYNCHR–MODE Fanuc Control Model: Series 0i-T, 16i/18i/21i-T, and 30i/31i/32i-T Fanuc Alarm Description T series In the synchronous operation, movement is commanded by the NC program or PMC axis control interface for the synchronous axis. Have you faced Fanuc Alarm 220 ILLEGAL COMMAND IN SYNCHR–MODE on your machine? Share your experience…

Fanuc Alarm 405: SERVO ALARM: (ZERO POINT RETURN FAULT) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Position control system fault. Due to an NC or servo system fault in the reference position return, there is the possibility that reference position return could not be executed correctly. Try…

Fanuc Alarm 5237: READ ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A floppy disk in the built–in Handy File cannot be read from. The floppy disk may be defective, or the head may be dirty. Alternatively, the Handy File is defective. Have you faced Fanuc Alarm…

Fanuc Alarm 5059: RADIUS IS OUT OF RANGE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A radius exceeding nine digits has been specified for circular interpolation with the center of the arc specified with I, J, and K. Have you faced Fanuc Alarm 5059 RADIUS IS OUT…

Fanuc Alarm 4701: PROGRAM ERROR (OT –) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The value specified in the X-axis move command exceeded the negative value of stored stroke limit 1. (Advance check) Have you faced Fanuc Alarm 4701 PROGRAM ERROR (OT –) on your machine? Share your…

Fanuc Alarm 5063: IS NOT PRESET AFTER REF. Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Function category: Workpiece thickness measurement Alarm details The position counter was not preset before the start of workpiece thickness measurement. This alarm is issued in the following cases;(1) An attempt has been…