Fanuc Alarm 109: FORMAT ERROR IN G08
Fanuc Control Model: Fanuc 0i-D/F, 16i/18i/21i, and 30i/31i/32i series
A value other than 0 or 1 was specified after P in the G08 code, or no value was specified.
Have you faced Fanuc Alarm 109 FORMAT ERROR IN G08 on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear this error faster!
Fanuc Alarm 5018: POLYGON SPINDLE SPEED ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Function category: Polygon turning;Alarm details: In G51.2 mode, the speed of the spindle or polygon synchronous axis either exceeds the clamp value or is too small. The specified rotation speed ratio thus cannot…
Fanuc Alarm 5012: G05 P10000 ILLEGAL START UP Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Function category: High–precision contour control;Alarm details: G05 P10000 has been specified in a mode from which the system cannot enter HPCC mode. Have you faced Fanuc Alarm 5012 G05 P10000 ILLEGAL START…
Fanuc Alarm 5123: OVER TOLERANCE OF END POINT Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The difference between a specified end point and the calculated end point exceeds the allowable range (parameter 3471). Have you faced Fanuc Alarm 5123 OVER TOLERANCE OF END POINT on your machine? Share…
Fanuc Alarm 124: MISSING END STATEMENT Fanuc Control Model: Fanuc 0i-D/F, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description DO – END does not correspond to 1: 1. Modify the program. Have you faced Fanuc Alarm 124 MISSING END STATEMENT on your machine? Share your experience or troubleshooting tips in the comments below to help other…
Fanuc Alarm 5300: SET ALL OFFSET DATAS AGAIN Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description After the inch/metric automatic conversion function (OIM: Bit 0 of parameter No. 5006) for tool offset data is enabled or disabled, all the tool offset data must be reset. This message reminds…
Fanuc Alarm 413: SERVO ALARM: n–th AXIS – LSI OVERFLOW Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The contents of the error register for the n–th axis (axis 1–8) exceeded ±231 power. This error usually occurs as the result of an improperly set parameters. Have you faced…