Fanuc Alarm 100: PARAMETER WRITE ENABLE

Fanuc Alarm 47: ILLEGAL AXIS SELECT Fanus Control Model: Fanuc Series 16, 18, 21, and the 16i/18i/21i Model C Description when the control system receives a command to move an axis that has not been properly defined, or when there is a conflict in the axis selection logic. How to Fix Alarm To resolve it,…

Fanuc Alarm 0: MISSING MOVE AFTER CHF/CNR Fanuc Control Model: Fanuc 0i, 16i / 18i / 21i, 30i / 31i / 32i Fanuc Alarm 51 (PS0051) is a Program/Software alarm that occurs during Chamfering (CHF) or Corner Rounding (CNR) operations. It triggers when the controller encounters a chamfering/corner rounding block that is not immediately followed…

Fanuc Alarm 5422: EXCESS VELOCITY IN G43.4/ G43.5 Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description As a result of pivot tool length compensation, an attempt was made to move the tool along an axis at a feedrate exceeding the maximum cutting feedrate. Have you faced Fanuc Alarm…

Fanuc Alarm 5245: OTHER AXIS ARE COMMANDED Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description One of the following command conditions was present during flexible synchronization or when flexible synchronization was turned on;1. The synchronous master axis or slave axis is the EGB axis.;2. The synchronous master axis…

Fanuc Alarm 5306: MODE CHANGE ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In a one–touch macro call, mode switching at the time of activation is not performed correctly. Have you faced Fanuc Alarm 5306 MODE CHANGE ERROR on your machine? Share your experience or troubleshooting tips in…