Fanuc Alarm 28: ILLEGAL PLANE SELECT

Fanuc Alarm 31: ILLEGAL P COMMAND IN G10 Fanus Control Model: Series 16i / 18i / 21i (Models A and B) and Series 30i / 31i / 32i Description When you use the ‘P’ command incorrectly with a G10 code. The value written after ‘P’ is either outside the offset number that is available in…

Fanuc Alarm 3: TOO MANY DIGITS Fanus Control Model: 16/18/21 Fanuc Alarm Description Data exceeding the maximum allowable number of digits was input. (Refer to the item of max. programmable dimensions.)

Fanuc Alarm 67: CAN NOT ERROR IN MDI MODE Fanus Control Model: 16/18/21 Fanuc Alarm Description T Series;G70, G71, G72, or G73 command with address P and Q. Modify the program.

Fanuc Alarm 118: PARENTHESIS NESTING ERROR Fanus Control Model: 16/18/21 Fanuc Alarm Description The nesting level of brackets or parentheses in a macro expression exceeds the limit of 5 levels.

Fanuc Alarm 110: DATA OVERFLOW Fanus Control Model: 10/11/12 Description This is a fault that usually appears when the controller’s data processing system is overloaded. This alarm indicates that the data you are entering into the machine or the calculation system is performing simultaneously has exceeded its memory or register limits. How to Fix Alarm…

Fanuc Alarm 34: NO CIRC ALLOWED IN ST–UP /EXT BLK Fanus Control Model: Series 0i / 16i / 18i / 21i / 31i / 32i Description This alarm (Fanuc Alarm 34) occurs when you are starting (Start-up block) or ending (Cancel block) Cutter Radius Compensation using G41 or G42, and write Circular Interpolation (G02/G03) instead…