Fanuc Alarm 10: IMPROPER G–CODE

Fanuc Alarm PS006: Illegal Use of Minus Sign Fanus Control Model: Series 0i (Model C, D, and F), Series 30i / 31i / 32i, Series 16i / 18i / 21i Description Minus Sign – is written in a place where it is not allowed. This alarm can sometimes be caused by a logical error in…

Fanuc Alarm 73: PROGRAM NUMBER ALREADY IN USE Fanus Control Model: 16/18/21 Fanuc Alarm Description The commanded program number has already been used. Change the program number or delete unnecessary programs and execute program registration again.

Fanuc Alarm 2: TV PARITY ALARM Fanus Control Model: 16/18/21 Fanuc Alarm Description TV alarm (The number of characters in a block is odd). This alarm will be generated only when the TV check is effective.

Fanuc Alarm 20: OVER TOLERANCE OF RADIUS Fanus Control Model: 16/18/21 Fanuc Alarm Description In circular interpolation (G02 or G03), difference of the distance between the start point and the center of an arc and that between the end point and the center of the arc exceeded the value specified in parameter No. 3410.

Fanuc Alarm 62: ILLEGAL COMMAND IN G71–G76 Fanus Control Model: 16/18/21 Fanuc Alarm Description T Series;1. The depth of cut in G71 or G72 is zero or negative value. 2. The repetitive count in G73 is zero or negative value. 3. the negative value is specified to Δi or Δk is zero in G74 or…

Fanuc Alarm 63: SEQUENCE NUMBER NOT FOUND Fanus Control Model: 16/18/21 Fanuc Alarm Description T Series;The sequence number specified by address P in G70, G71, G72, or G73 command cannot be searched. Modify the program.