Fanuc Alarm 5252: ILLEGAL P COMMAND IN G54.2
Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series
The P value specifying the offset number of a fixture offset is too large. Correct the program.
Have you faced Fanuc Alarm 5252 ILLEGAL P COMMAND IN G54.2 on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear this error faster!
Fanuc Alarm 4507: ILLEGAL COMMAND IN SQUARE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In a square (G87) command, the tool size (P,Q) was set to zero or a negative value, or the blanking length (I, J) was three times larger than the tool size (P, Q)…
Fanuc Alarm 5245: OTHER AXIS ARE COMMANDED Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description One of the following command conditions was present during flexible synchronization or when flexible synchronization was turned on;1. The synchronous master axis or slave axis is the EGB axis.;2. The synchronous master axis…
Fanuc Alarm 5010: END OF RECORD Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The end of record (%) was specified. I/O is incorrect. modify the program. Have you faced Fanuc Alarm 5010 END OF RECORD on your machine? Share your experience or troubleshooting tips in the comments below…
Fanuc Alarm 5124: CAN NOT COMMAND SPIRAL Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A spiral interpolation or conical interpolation was specified in any of the following modes;1) Scaling;2) Programmable mirror image;3) Polar coordinate interpolation In cutter compensation C mode, the center is set as the start…
Fanuc Alarm 5018: POLYGON SPINDLE SPEED ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Function category: Polygon turning;Alarm details: In G51.2 mode, the speed of the spindle or polygon synchronous axis either exceeds the clamp value or is too small. The specified rotation speed ratio thus cannot…
Fanuc Alarm PS891: ILLEGAL COMMAND G05 Fanus Control Model: Series 15 control (including Series 15-MA, 15-TA, 15-MF, and 15-TF). Description When the G05 command is written incorrectly in the program or the controller detects a technical error in the use of the G05 command. One reason for this alarm is that the G05 command is…