Fanuc Alarm 4542: MULTI-PIECE COMMAND ERROR

Fanuc Alarm 5012: G05 P10000 ILLEGAL START UP Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Function category: High–precision contour control;Alarm details: G05 P10000 has been specified in a mode from which the system cannot enter HPCC mode. Have you faced Fanuc Alarm 5012 G05 P10000 ILLEGAL START…

Fanuc Alarm 5245: OTHER AXIS ARE COMMANDED Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description One of the following command conditions was present during flexible synchronization or when flexible synchronization was turned on;1. The synchronous master axis or slave axis is the EGB axis.;2. The synchronous master axis…

Fanuc Alarm 5067: (HPCC) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description HPCC mode cannot be canceled during G51 (scaling) or G68 (coordinate system rotation). Correct the program. Have you faced Fanuc Alarm 5067 (HPCC) on your machine? Share your experience or troubleshooting tips in the comments below to…

Fanuc Alarm 415: SERVO ALARM: n–TH AXIS – EXCESS SHIFT Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A speed higher than 524288000 units/s was attempted to be set in the n–th axis (axis 1–8). This error occurs as the result of improperly set CMR. Have you faced…

Fanuc Alarm 71: DATA NOT FOUND Fanuc Control Model: Series 0 / 0-Mate / 0i (Model A, B, C, D, F), 16 / 18 / 21 and 16i / 18i / 21i, 160i / 180i / 210i, 30i / 31i / 32i Fanuc Alarm Description The address to be searched was not found. Or the…